Hi, I'd like to ask for some suggestions on how to do proper imaging in Pier 6, I can't seem to pull out colors after doing stacking(ASTAP) and colorize(gimp) on my data.
I initially did the stacking with flats and darks in DSS(VirtualBox) but I encountered the issue, so to isolate the issue if its my workflow or my data capture
I switch to ASTAP did the stacking again using RGB data only and compared the result using the same workflow with the RGB sample IC43 data from the website.
With the sample IC43 data I was able to get a good starting point of stacked/colorized data. So it must be something on how I set up the capture on Pier 6, I'd like to take another shot
at Pier 6 but would like to get some suggestions first how should I do the capture.
Here's my capture settings L-3@300s, R-3@300s, G-3@300s, B-3@300s.